1. Press menu.    
2. Go to Installation then press OK.
3. Press OK on Satellite.
4. Choose your desire Satellite (for USA usually is Galaxy 25) after pressing OK on your desired satellite press exit.
5. Go down high light Antenna Configuration press OK.
6. Make sure the LNB Type is correct, default is standard if have a different type, change it by high lighting the LNB Type and pressing the VOL+ key.
7. Press exit.
8. High light Edit TP press OK.
9.  High light TP INDEX press vol+ to get to a known and working transponder for example TP 6  frequencies 11789 SB 28113 or TP 7 Fre. 11836 SB 20770 or TP 8 Fre.11874 SB 22000.
10. If Strength and Quality both have green bar Strength More than 80% and quality more than 50% your dish is aligned to Galaxy 25. (If no Quality bar that means you have to align your dish. Or check to see if your LNB has not been damaged by the natural causes like heat or cold. The most important about the LNB is the white plastic cap is not broken or cracked). If you have the strength and quality.
11.  Press Exit.
12. To do a blind scan of Galaxy 25when you are in installation menu  press the Red Button on your remote, this would search the satellite and downloads all of the transponders and channels in that satellite. If the scan stopped at 50% press OK then press exit to cancel the download and repeat this step again to get a 100%. Then follow the on screen steps, take default. When scan is finished press exit until you are back to the screen.

    Back